HURST "T" HANDLE SHIFT KNOB RETRO HOTROD RATROD

Description

NEW HURST T-HANDLE IN BUBBLE WRAP BAG
RECESSED HURST LOGO , BRUSHED FINISH...
THIS WAS INTENDED TO GET THE PUSH BUTTON ON THE SIDE ,SO IS DRILLED WITH A 5/8 HOLE ON THE DRIVERS SIDE 1 INCH DEEP WITH A WIRE HOLE COMING FROM THE BOTTOM OF IT , AIMED AT THE SHIFT LEVER ...HANDLE IS THREADED 12MM X 1.75.
JUST TO SEE HOW IT WOULD WORK,I TOOK THE 1ST HANDLE AND PUT A 3/8-16 HELICOIL IN IT, I DIDN'T EVEN NEED TO DRILL IT OUT,JUST USED THE 3/8 HELICOIL TAP THEN SCREWED THE HELICOIL RIGHT IN...MEANING THIS COULD BE MADE TO FIT ANY LEVER 3/8-16 OR LARGER...I DO HAVE THESE LISTED WITH THE 3/8-16 HELICOIL INSTALLED ALREADY,SEE LINK BELOW  FOR IT...
http://www.ebay.com/itm/171362112433?item=171362112433&viewitem=&vxp=mtr
IF I FIND THE APPROPRIATE BUTTON I WILL OFFER THESE LATER WITH BUTTONS BUT NONE SO FAR...
THANKS FOR LOOKING AND PLEASE CHECK OUT MY OTHER LISTINGS,
I DO COMBINE SHIPPING
please see my other auctions for more cool stuff....thanks for looking!!